Find replacement parts for your e-bike at Escapa.
TheBrose T and S Motor Belt Kit lets you replace the Brose motor belt so it’s as good as new. The belt is the new 2020 model, which is more durable than the original.
Brose belt kit for T and S model motors (aluminum)
Original Brose carbon-reinforced belt made from the same compound as the belts that come factory-installed on 2020 motors
The kit contains:
Carbon-reinforced belt
Motor cover gasket
O-ring to seal the gap between the cover and the shaft
Thin O-ring that fits into the small circular hole in the housing.
Belt tensioning screw, which must be tightened to 0.2 Nm; otherwise, the belt will break during use
Warranty sticker
Brose S or T, for Brose S and Brose T motors, or the Specialized 1.2 and 1.3 models
- The belt tensioner screw must be tightened to 0.2 Nm; otherwise, the belt will break during use. To measure the 0.2 Nm correctly, you must first remove the dry threadlocker to obtain an accurate torque reading. This tightening is done last, after the cover has been closed. Apply new threadlocker to the screw.
- It is recommended to apply a generous amount of petroleum jelly to the entire belt, both on the inside and outside.
- The thin gasket goes into the small circular opening in the housing.
- The large seal is used to seal the gap between the cover and the shaft.
